[. . . ] The Power/Memory light on the back of the camera will start blinking to show that the battery is charging. When the Power/Memory light stops blinking, the battery is fully charged, and you can then unplug the power adapter from the camera. You can continue to use the camera while the battery is being charged by the power adapter. The first time you turn the camera on, you are prompted to choose a language. [. . . ] The lens extends and the Power/Memory light to the left of the switch turns solid green. Scroll to the language that you want by using the buttons on the Controller . After choosing a language, you are prompted to choose the continent where you live. If the date and time format is correct, press the button to move to the Date. Press the button when you have entered the proper values for the date and time. A confirmation screen appears, asking if the correct date and time have been set. Your camera contains internal memory that allows you to store images and video clips. However, you can use a memory card (purchased separately) instead to store images and video clips. Turn off the camera and open the Battery/Memory card door on the bottom of the camera. Insert the memory card in the small slot above the battery, with the notched side of the card going in first, as shown. To help prevent corrupted cards and images, you should format memory cards before you use them for the first time. When the HP Image Zone software has finished installing, re-enable the virus protection software that you disabled in Step 1. Turn off the camera, then connect the camera to the computer either through the USB cable provided or through the optional HP Photosmart R-series dock (see NOTE below). Follow the on-screen instructions to have the software transfer the images from the camera to the computer. NOTE: If using the dock, make sure you use the dock insert with the GREEN sticker on it. English HP Instant Share lets you easily select still images in your camera to be automatically sent to a variety of destinations such as e-mail addresses, the next time you connect the camera to your computer. You must have the full version of the HP Image Zone software on your computer to use this part of the HP Instant Share feature on your camera. NOTE: You will need an Internet connection to complete this procedure. Turn on the camera, press the button, then use the button to move to the HP Instant Share Menu . A message will appear in the Image Display asking you to connect the camera to your computer. Without turning off the camera, connect it to your computer again using the same procedure you used in the previous section, Transfer Images to a Computer. The next step is slightly different on a Windows and Macintosh computer: · windows: Connecting the camera to the computer activates the HP Instant Share Setup program. [. . . ] If some other dialog box appears in addition, close that dialog box by clicking Cancel. In the HP Instant Share Setup program, click Start, then simply follow the onscreen instructions to set up destinations on the computer and save them to your camera. Click Continue, then simply follow the on-screen instructions to set up destinations on the computer and save them to your camera. Disconnect the camera from the computer, then go back to the HP Instant Share Menu to check that the new destinations are now in the camera. [. . . ]